Grass Valley K2 Edge Installation v.4.0.2 User Manual

K2 edge installation and service manual

Table of contents

Document Outline

1 Grass Valley Product Support
2 Safety Summaries
3 About this document
4 Shipping kit contents
5 Credentials
6 Site preparation
- 6.1 Physical Specifications
- 6.2 Environmental Requirements
- 6.3 Cable advice
7 K2 Edge Front Panel
8 K2 Edge Back Panel (connectors)
9 Indicators and status information
- 9.1 Power supply indicator
- 9.2 IP Manager connection indicator
- 9.3 LAN connection indicator
- 9.4 LEDs (hard disks)
10 The IP Manager: introduction
- 10.1 The LCD front panel
- 10.2 Starting the IP Manager web interface
11 Server installation and initial setup
- 11.1 Connecting the server to the LAN and connecting the IP Manager
- 11.2 Connecting the IOs
- 11.3 Connecting the VGA-monitor (optional)
- 11.4 Connecting blackburst, GPIO and LTC (optional)
- 11.5 Connecting the power cables and power on
- 11.6 Configuring the IP Manager
- 11.7 Configuring the K2 Edge hostname and network settings
- 11.8 Specifying the TX/MAM database IP-address
12 Channel Presets
- 12.1 Introduction
- 12.2 Configuring K2 Edge Channels and ports
- 12.3 Time settings
13 Service Instructions
- 13.1 Server Power
  - 13.1.1 Powering on the Server
  - 13.1.2 Powering off the Server (shutdown)
- 13.2 Replacing the front bezel
- 13.3 Replacing a hard disk
- 13.4 Replacing a redundant power supply module
14 Appendix: The IP Manager Quick Reference
- 14.1 Starting the IP Manager web interface
- 14.2 The LCD front panel
- 14.3 The IP Manager menu
- 14.4 System configuration
- 14.5 System monitoring
- 14.6 System administration
15 Appendix: time settings
16 Appendix: Changing an IP-address
17 Appendix: K2 Edge network ports
18 Appendix: K2 Edge IOs
- 18.1 Tiles
- 18.2 Bypass
- 18.3 Master and Slaves
- 18.4 Genlock
19 Appendix: Supported input/output broadcast format combinations
20 Appendix: GPIO and LTC pinning
21 Appendix: Yast