Grass Valley FXC-S201 - Manual (Page 22)

18
Setting Up the CommLink FXC-S201
About Setting up the CommLink FXC-S201
About Setting up the CommLink FXC-S201
Use of the CommLink FXC-S201 Fiber Optic Intercom Link system first requires the setup
and connection of the Intercom System and the CommLink FXC-S201 units. The second
step is the proper configuration or setting of switches on the CommLink FXC-S201 front
panel. If two-wire systems are in use, the Auto Null function should be employed.
Each system setup is based on the appropriate mix of the three physical types of the
CommLink FXC-S201 Fiber Optic Intercom Link. Depending on your particular operation
the combination of units may be all the same physical type or a mix and match. Whatever
the physical configuration of the units, the single-fiber solution requires a 1310mm WDM
and 1550mm WDM pair. It makes no difference where the WDM units are placed in the
system. If the CommLink FXC-S201 Fiber Optic Intercom Link is being used locally to
convert between intercom system types, either WDM type can be used