Grass Valley FXC-S201 User Manual

Page 14

System Overview

CommLink FXC-S201 Fiber Optic Intercom Link Back Panel

• Green when audio activity is below 0 db

• Red when audio activity is above 0 db

• 9: Data Activity Indicator

• Green when there is data activity on the particular channel

• 10: Power Indicator

• Green indicates power

• 11: Link Status Indicator

• Green indicates link is good

• Red indicates link is bad or non-existent.

CommLink FXC-S201 Fiber Optic Intercom Link Back Panel

Fig. 2-9: CommLink FXC-S201 Back Panel

1 11-18 VDC Power Connector - for use with the ADAP-AC-04 Power Supply.

This power supply has a 4-pin XLR connector. See

on page 15 for wiring information.

2 RTS/CC-1 Chassis Mounted XLR Connector - for RTS TW operation or Channel 1 of

Clear-Com two wire operation

3 CC-2 Chassis Mounted XLR Connector - for Channel 2 of Clear-Com two wire

operation. Not active when the system is in RTS-TW mode.

Connectors 4 and 5 operate in one of 4 modes, depending on system configuration.
These connectors can be used with RJ45 cables or RJ11 cables. See

information and for wiring information.

4 4W-CH1 Connector - 8 Conductor RJ45/RJ11 connector for Channel 1 in 4-wire

operation.