Grass Valley Personal Locator System CameraMan - Manual (Page 11)

Page 8 CameraMan ® Personal Locator Camera System Installation and Operations Manual
The MY TURN Button
Press the MY TURN button on your Keypad. The camera will
then pan, tilt and zoom in on you to show a close-up view.
If you would like to alter this view, or if the camera goes to
another location, you will need to reset the MY
TURN button to focus on your location.
To Set Or Change The MY TURN Button
1. Use the PAN/TILT arrows to position yourself in
the middle of the video frame.
2. Only when desired, use the ZOOM buttons to
set the needed zoom perspective.
3. Only when desired, use the manual IMAGE
buttons to set the needed light/dark
contrast.
4. On 3-CCD Keypads, adjust the FOCUS
control to obtain optimum image sharpness
(1-CCD cameras are autofocus)
5. Press and hold the MY TURN button until
you hear two beeps from the keypad
indicating the new setting has been stored in
the camera’s memory.
To Recall The MY TURN View
Press and release the MY TURN button. The camera will then recall the
information previously stored with the MY TURN button.
Note: Each Keypad stores an individual location preset in the
camera’s memory. The camera does not follow the keypad, but
will recall the location preset stored with the MY TURN button.
Using The Keypad Controls
Programming/Changing the MY TURN and GROUP Buttons
The MY TURN & GROUP buttons will store and recall a PAN/TILT position and a ZOOM
perspective with an IMAGE setting from the camera’s memory.
After programming the initial camera-views, you may want to allow the participants to
customize the MY TURN view to their needs. Use the following procedures to set, or change
the camera-view associated with each keypad.
The GROUP Button
Press the GROUP button twice on your Keypad. The
camera will show a wide-angle shot of all the
participants in the videoconference. If you would like to
alter the image in this view, you will need to reset the
GROUP button. If the camera goes to another location
altogether you will need to reset the GROUP button to
focus on the appropriate GROUP view.
To Set Or Change The GROUP Button:
1. Use the PAN/TILT arrows to position the camera to
the desired location.
2. Only when desired, use the ZOOM buttons to set
the needed zoom perspective.
3. Only when desired, use the manual IMAGE buttons
to set the needed light/dark contrast.
4. On 3-CCD Keypads, adjust the FOCUS control to
obtain optimum image sharpness (1-CCD cameras
are autofocus).
5. Press and hold the GROUP button until you hear two
beeps from the keypad indicating the new setting
has been stored in the camera’s memory.
To Recall The GROUP View:
Press and release the GROUP button twice. The camera will then recall
the information previously stored with the GROUP button.
Note: The GROUP view can only be adjusted with the
Chairperson Locator Keypad.
To set up your videoconference, you will need to adjust the camera-view associated with each keypad’s MY TURN and GROUP
buttons. After the initial setup, modification of these features is not required for system operation, but they are available if needed.