Grass Valley 3-CCD ANALOG CameraMan Rev.D1 - Manual (Page 7)

Page 4
CameraMan® 3-CCD ANALOG Camera Installation and Operations Manual
CameraMan 3-CCD ANALOG Camera
The camera and its integrated intelligent pan/tilt system is the primary
component, and the basis for all of the CameraMan camera systems.
The 18x version of the 3-CCD ANALOG
Camera includes a rectangular lens shroud.
See Appendix F: page 22 for instructions on
how to install the shroud.
Mini Docking Station
The Mini Docking Station should be attached to the back of the camera.
This box is the point of connection for all RS-232 and RS-485. The only
time this box needs to be removed is if the camera is upgraded to a
Presenter Camera System.
Note: If a Presenter or Deluxe Camera System was purchased,
the Mini Docking Station is not needed.
CameraMan Power Supply
The included power supply enables use with 50/60 Hz, 100-240V Power
sources.
Connection Accessories
• RS-485 Connector “T”
• 3’ CameraMan Communication Cable
• 25’ CameraMan Keypad Cable
Below is a description of each part that came with the CameraMan 3-CCD ANALOG
Camera.
3-CCD ANALOG Camera Components
Power Supply
Non-functional
3-CCD Cameras
Mini Docking Station
Top of T-connector with RS-485 cables.
Front and back of T-connector
Front View of CameraMan 3-CCD
ANALOG Camera Rear View of CameraMan 3-CCD
ANALOG Camera