Grass Valley 3-CCD ANALOG CameraMan Rev.D1 - Manual (Page 17)

Page 14
CameraMan® 3-CCD ANALOG Camera Installation and Operations Manual
System Startup
Once all necessary connections and configurations are made, you are ready to turn
on the system.
3. Connect the other end of the power supply into a 120 VAC source.
Powering On
1. Just switch the Power button on the back of the CameraMan ANALOG Camera to the ON position. The Camera
should automatically enter its position calibration mode and then stop at the zero degree point.
2. Verify that the camera is now facing in the direction the "FRONT" label was pointing during mounting (see page 8).
3. If you are using the optional Camera Control Keypad or PVTV SHOT Director, make sure its base unit address is the
same as on the camera. If they are, verify that the camera’s PAN and TILT functions are working properly.
Cameras 1-16 on PVTV SHOT Director correspond to Base Unit Addresses 0-F respectively: 1=0,
2=1, 3=2....11=A, etc.
Back of ANALOG Camera
with power supply