Grass Valley 8949MDA-CFR v.2.6.0 - Manual (Page 17)

8949MDA-CFR/-SFR — Instruction Manual 17
Installation
Optional Fiber Optic SFP Device Installation
After the front and rear modules have been installed, install the optional
fiber optic SFP device option if being used into the rear module metal cage
labeled FIBER (
Figure 5 on page 18 ). The SFP device is hot-pluggable and
may be installed or removed with power applied to the module.
CAUTION Use anti-static precautions and handle the SFP device carefully when
installing and the removing it. Before inserting the fiber cable, it is important
to clean all fiber connections as described in Fiber Optic Cleaning Require-
ment below.
Refer to Table 2 for the correct model of SFP device to use with different
software versions.
Fiber Optic Cleaning Requirement
Before making any fiber optic cable mating connections, including installa-
tion, and after every de-mating cycle, use an industry standard fiber optic
cleaning kit, including oil-free compressed air, to clean the fiber connectors
and the connectorized fiber end faces. This helps ensure optimum perfor-
mance of the fiber optic interface. Industry standard fiber optic cleaning
kits can be purchased on the web and in electronics stores.
Table 2. Fiber Optic SFP Device Summary
SFP Device Model Type SW 2.4.1 and later SW 2.4.1 and earlier
SFP-13103G-M2DRX Dual Receiver Yes No
SFP-13103G-M2DTX Dual Transmitter Yes No
SFP-13103G-M2TRX Transceiver Yes No
1310nm-DRL Dual Receiver Yes Yes
1310nm-DTL Dual Transmitter Yes Yes
1310nm-TRL Transceiver Yes Yes