Grass Valley 8920DMX - Manual (Page 18)

18 8920DMX Instruction Manual
Configuration
Signal Configuration Displays
This section discusses in detail the signal configuration displays used to
setup the 8920DMX module output configuration.
Audio Group Management
The Audio Group Management display (see Figure 8 ) allows you to
perform the following functions:
• Select the Output action for the module (Extract and pass or delete one
of four audio groups to the SD output),
• Choose the source of CRC/UVC generation from External (CRC/UVC is
generated from input signal) or Internal (CRC/UVC is generated inter-
nally), and
• Enable or disable SD input reporting for applications where this
reporting is not desirable or required. When set to Disabled, the SD
Input graphic on the Status page will be gray, showing this signal as not
monitored. See
Status Monitoring on page 22 .
Click the Apply button to activate a selection.
The status reporting section of the display provides monitoring of:
• Audio groups present in the SD input,
• Status of the group extract/pass/delete action, and
• Audio groups present in the SD output.
CAUTION When monitoring the status of the signal configuration, be aware that this
page is a static display and requires manual refresh. Changing SD input
upstream can cause changes to the 8920DMX output that will not be reported
until status refresh is activated. To refresh the status information click on the
page link or Refresh button (8900NET software version 3.0 and later).
Use
This
Link