H3C Technologies H3C Intelligent Management Center - Manual (Page 71)

62
After IMC installation is complete, how do I change the Web service
port numbers of the server installed with IMC?
Use the setwebport tool to change the IMC Web service port numbers:
1. Run \client\bin\setwebport.bat (on Windows) or
/client/bin/setwebport.sh (on Linux) in the IMC installation path.
This example uses Windows.
2. Change the HTTP port number from 8080 to 80, and the HTTPS port
number from 8443 to 443, as shown in
Figure 31 .
Figure 31 Execution result of the setwebport.bat tool
3. Restart the jserver process.
4. If IMC is deployed in distributed mode, repeat the preceding steps on
every server installed with IMC.
5. If the UAM module is installed, change the IMC service port number to
the new HTTP port number. Otherwise, the guest manager cannot
formally register the pre-registered guests.
To change the IMC service port number, do the following:
a. Click the User tab on the top navigation bar, and then select User
Access Policy Manager > Service Parameters.
The Service Parameters page appears.