H3C Technologies H3C SecPath U200-A U200-M U200-S - Manual (Page 50)

41
2. Holding the clasp of the MIM interface module, gently pull out the MIM interface module along
the slide rails.
3. Install a new MIM interface module.
For the installation procedures, see "
Installing a MIM interface module ."
If no new MIM interface module is to be installed to the slot, install a filler panel to prevent dust
from entering the chassis.
Figure 42 Pulling out a MIM interface module
Replacing a CF card
CAUTION:
To avoid hardware damage, do not remove the CF card when the UTM device is booting or the LED is
flashing.
To replace a CF Card:
1. Check whether the CF card LED is flashing. If yes, the system is accessing the CF card. Proceed to
the next step after the LED stops flashing.
2. Press the CF card eject button so that the eject button projects from the panel.
3. Press the eject button again to eject the CF card part-way out of the slot.
4. Pull the CF card out of the slot.
To protect the removed CF card, place it in an antistatic bag.
5. Install a new CF card.
For the installation procedures, see "
Installing a CF card ."
Figure 43 Removing a CF card