H3C Technologies H3C SecPath U200-A U200-M U200-S - Manual (Page 15)

6
Preparing for installation
Safety recommendations
To avoid possible bodily injury and equipment damage, read all safety recommendations carefully
before installation. Note that the recommendations do not cover every possible hazardous condition.
Safety symbols
When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.
Electricity safety
• Locate the emergency power-off switch in the room before installation. Shut the power off at once
in case accident occurs.
• Make sure the UTM device has been correctly grounded.
• Use an uninterrupted power supply (UPS).
• Do not work alone when the UTM device has power.
• Always check that the power is off.
Laser safety
The UTM device is a Class 1 laser product.
WARNING!
•
Do not stare into any fiber port when the UTM device has power. The laser light emitted from the
optical fiber may hurt your eyes.
• Use a fiber test equipment, rather than a microscope or magnifier to observe an operating fiber
connector or port when you test link connectivity or system parameters.
Handling safety
When you move the UTM device, follow these guidelines:
• Remove all external cables, including the power cords, before moving the chassis.
• Lift and put down the chassis slowly and never move suddenly.
• When you move multiple UTM devices, use a pallet jack.