beautypg.com

Resetting/terminating a pppoe session, Displaying and maintaining pppoe – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 23

background image

5-3

z

A permanent PPPoE session is established immediately when the line is physically up. It remains

valid till a user terminates it explicitly.

z

A packet-triggered PPPoE session is established when there is a demand for data transmitting. It is

terminated when idled for a specific period of time. That is, a packet-triggered PPPoE session may

not be established even if the line is physically up.

z

A diagnostic PPPoE session is established immediately after the AP configuration is complete. The

AP automatically terminates and then tries to re-establish diagnostic PPPoE sessions at a

pre-configured interval, and by doing so, monitors the status of the PPPoE links.

You can establish a PPPoE session on a VLAN interface.

Follow these steps to configure a PPPoE session:

To do...

Use the command...

Remarks

Enter system view

system-view

Enter VLAN interface view

interface ethernet interface-number

Create a PPPoE session, and specify a
dialer bundle for the session

pppoe-client dial-bundle-number number
[ no-hostuniq ] [ diagnose [ interval
seconds ] | idle-timeout seconds
[ queue-length packets ] ]

Required

You can establish multiple PPPoE sessions on a VLAN interface, in other words, a VLAN interface can

belong to multiple dialer bundles at the same time. However, a dialer bundle can have only one VLAN

interface. A PPPoE session uniquely corresponds to a dialer bundle and vise versa.

Resetting/Terminating a PPPoE Session

Follow these steps to reset/terminate a PPPoE session:

To do…

Use the command…

Remarks

Reset a PPPoE session on a
PPPoE client

reset pppoe-client { all |
dial-bundle-number number }

Available in user view

Terminate a PPPoE session on a
PPPoE client

undo pppoe-client
dial-bundle-number
number

Available in VLAN interface view

Displaying and Maintaining PPPoE

To do…

Use the command…

Remarks

Display the statistics and state
information about a PPPoE client

display pppoe-client session
{ packet | summary }
[ dial-bundle-number number ]

Available in any view

This manual is related to the following products: