beautypg.com

Configuring a pppoe client, Configuring a dialer interface, Configuring a pppoe session – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 22

background image

5-2

Figure 5-1 Network diagram for PPPoE configuration

Configuring a PPPoE Client

PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.

Configuring a Dialer Interface

Before establishing a PPPoE session, you must first create a dialer interface and configure a dialer

bundle on the interface. Each PPPoE session uniquely corresponds to a dialer bundle and each dialer

bundle uniquely corresponds to a dialer interface. Thus, a PPPoE session uniquely corresponds to a

dialer interface.

Follow these steps to configure a dialer interface:

To do...

Use the command...

Remarks

Enter system view

system-view

Configure a dialer rule

dialer-rule dialer-group { protocol-name
{ permit | deny } | acl acl-number }

Required

Create a dialer interface

interface dialer number Required

Create a dialer user

dialer user username

Required

Assign an IP address to the interface

ip address { address mask |
ppp-negotiate }

Required

Create a dialer bundle on the interface

dialer bundle bundle-number Required

Create a dialer group on the interface

dialer-group group-number Required

You can also configure PPP authentication or set other parameters on the dialer interface as needed.

Configuring a PPPoE Session

PPPoE sessions fall into these categories: permanent PPPoE session, packet-triggered PPPoE

session, and diagnostic PPPoE session.

This manual is related to the following products: