Configuring ppp – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 14
4-4
Figure 4-3 PPP operation flow chart
For more information about PPP, see RFC 1661.
Configuring PPP
Configuring PPP
Follow these steps to configure PPP:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Configure PPP as the data link layer
protocol
link-protocol ppp
Optional
By default, PPP is used.
Set the polling interval
timer hold seconds
Optional
10 seconds by default
Configure PAP
authentication
For more information, see
Configuring PAP Authentication
Configure PPP
authentication
mode
Configure CHAP
authentication
For more information, see
Configuring CHAP
Authentication
.
Optional
Select either authentication
mode
By default, PPP authentication
is disabled.
Configure PPP negotiation
For more information, see
.
Optional
Enable the generating of PPP
accounting statistics
For more information, see
Enabling the Generating of PPP
Accounting Statistics
Optional
This document only discusses local authentication. For more information about remote AAA
authentication, see AAA in the Security Configuration Guide.