beautypg.com

Configuring ppp negotiation parameters, Introduction to ppp accounting statistics, Troubleshooting ppp configuration – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 19

background image

4-9

Currently, the AP can only operate as a client.

Configuring PPP negotiation parameters

Follow these steps to configure PPP negotiation parameters:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter interface view

interface interface-type interface-number

Configure the negotiation timeout
time

ppp timer negotiate seconds

Optional

3 seconds by default

Configure the IP address
negotiation

ip address ppp-negotiate Optional

Enabling the Generating of PPP Accounting Statistics

Introduction to PPP accounting statistics

PPP can generate traffic-based accounting statistics on each PPP link. The statistics include the

amount of the inbound and outbound information (in terms of bytes and the number of the packets) on a

link. The information can be used by AAA application modules for accounting and control purpose.

Enabling the generating of PPP accounting statistics

Following these steps to enable the generating of PPP accounting statistics:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter interface view

interface interface-type
interface-number

Enable the generating of PPP
accounting statistics

ppp account-statistics enable

Required

Disabled by default.

Troubleshooting PPP Configuration

Symptom 1: PPP authentication fails and the link cannot be brought up.

Solution: This problem may arise if the parameters for authentication are incorrect.

Enable the debugging of PPP, and you can see the information showing that LCP went up upon a

successful LCP negotiation but went down after PAP or CHAP negotiation.

Check the PPP authentication settings at the local and peer ends to make sure that they are consistent.

See the part talking about PPP authentication configuration for reference.

Symptom 2: Physical link is down.

Solution: The physical link is down when:

z

The interface is not brought up.

This manual is related to the following products: