H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 15)

5-5
To do… Use the command… Remarks
Exit interface view quit Required
Create a WLAN service
template
wlan service-template
service-template-number
{ clear | crypto }
Required
By default, no service template is created.
Specify the service set
identifier (SSID)
ssid ssid-name
Required
By default, no SSID is set.
Bind the WLAN-ESS
interface to the service
template
bind wlan-ess interface-index
Optional
By default, no WLAN-ESS interface is bound
to the service template..
Enable the authentication
method authentication-method
{ open-system | shared-key }
Required
By default, open system authentication is
enabled.
You can enable open system authentication,
shared key authentication, or both.
Enable the service template service-template enable
Required
By default, the service-template is disabled.
Exit interface view quit Required
Configuring an AP
Specify the AP name and its
model number and enter AP
template view
wlan ap ap-name model
model-name
Required
The model number needs to be specified only
during new AP template creation.
Exit interface view quit Required
Enable WLAN radios
wlan radio { disable |
enable } { radio-policy
radio-policy-name | all |
dot11a | dot11an | dot11b |
dot11g | dot11gn }
Required
By default, no WLAN radio is enabled.
Configuring the radio of an AP
Enter AP template view
wlan ap ap-name model
model-name
Required
Specify a radio type for the
radio and enter radio view
radio radio-number [ type
{ dot11a | dot11an |dot11b |
dot11g | dot11gn } ] Required
Support for this command depends on the AP
model.
Enable the radio radio enable
Required
By default, all radios are disabled.
Exit interface view quit Required
Saving the Current Configuration
You can modify the current configuration on your AC at the CLI. However, the current configuration is
temporary. To make the modified configuration take effect at the next startup, you must save the current
configuration to the startup configuration file.
Complete these tasks to save the current configuration: