H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 12)

5-2
interface NULL0
#
interface Vlan-interface1
ip address 192.168.0.100 255.255.255.0
#
interface GigabitEthernet1/0/1
#
interface GigabitEthernet1/0/2
#
interface GigabitEthernet1/0/3
#
interface GigabitEthernet1/0/4
#
interface Ten-GigabitEthernet1/0/5
#
load xml-configuration
#
user-interface con 0
user-interface vty 0 4
authentication-mode scheme
user privilege level 3
#
return
Table 5-1 Description of the default configuration
Field Description
version 5.20, Release 2106P01 The AC software version currently in use
sysname H3C The default sysname is H3C.
undo info-center logfile enable Disable the logfile function.
domain default enable system The default enabled domain is system.
telnet server enable By default, telnet server is enabled.
port-security enable By default, port security is enabled.
vlan 1
VLAN 1 is the default VLAN, and you cannot create and
delete a default VLAN.
domain system
access-limit disable
state active
idle-cut disable
self-service-url disable
Basic configurations in the default domain system:
The number of associated clients is not limited.
Specify the current domain to be in the active state.
Disable the idle-cut function for the current ISP domain.
Disable the location function of the self-service server.
user-group system
system is the default user group. You cannot delete the
default user group but you can modify its configuration.
local-user admin
password simple admin
authorization-attribute level 3
service-type telnet
The default configuration of the local user is as follows:
z The username is admin.
z The password is admin, case sensitive.
z The user level is 3 (manage level).
z The service type is telnet.