H3C Technologies H3C MSR 930 - Manual (Page 14)

7
Mounting the router on a workbench
IMPORTANT:
•
Reserve a space of 10 cm (3.9 in) around the router for heat dissipation.
• Do not place heavy objects on the router.
To mount the router on a workbench:
1. Make sure the workbench is clean, stable, and properly grounded.
2. Place the router upside down on the workbench and attach the rubber feet to the four round
holes in the chassis bottom.
Figure 2 Mounting the router on a workbench
Installing the router on a wall
CAUTION:
When mounting the router on a wall, position the router so the network interfaces face downwards,
and the sides with ventilation openings are perpendicular to the ground, as shown in
Figure 3 .
To mount the router on a wall:
1. Mark the locations of the two mounting holes on the wall with the separations listed as follows:
Router model Separation
MSR 930, MSR 930-GU, and MSR 930-GT 180 mm (7.09 in)
MSR 930-DG, and MSR 930-SA 240 mm (9.45 in)
The holes must be level (on the same horizontal line.)
2. Drill two holes in the wall.
3. Following the marks, drill the two holes at least 22 mm (0.87 in) deep.
Verify that the holes are level.
4. Insert an anchor into each hole so it is flush with the wall surface.
5. Drive a screw into each anchor, keeping the screw heads protruding at least 1.5 mm (0.06 in)
from the wall.
6. Hang the router on the screws.