H3C Technologies H3C MSR 50 - Manual (Page 13)

7
Start to execute install script file...
Check for install...Ok
Fdisk hard disk...Ok
Make hard disk file system...Ok
Mount hard disk...Ok
Get hd-mim-oaps-v2-centos.tar.gz file...Ok
Decompressing hd-mim-oaps-v2-centos.tar.gz file...
decompress alt.tar.gz ok
decompress bin.tar.gz ok
decompress boot.tar.gz ok
decompress dev.tar.gz ok
decompress etc.tar.gz ok
decompress home.tar.gz ok
decompress lib.tar.gz ok
decompress lib64.tar.gz ok
decompress media.tar.gz ok
decompress misc.tar.gz ok
decompress mnt.tar.gz ok
decompress opt.tar.gz ok
decompress proc.tar.gz ok
decompress root.tar.gz ok
decompress sbin.tar.gz ok
decompress selinux.tar.gz ok
decompress srv.tar.gz ok
decompress sys.tar.gz ok
decompress tmp.tar.gz ok
decompress usr.tar.gz ok
decompress var.tar.gz ok
Mount nandflash...Ok
Create grub conf file...Ok
Update grub...Ok
OAP install completed
7. Reboot the OAP/OAPS module until the operating system is started.
CentOS release 5.4 (Final)
Kernel 2.6.18-164.el5 on an x86_64
localhost login:
8. Enter the username and password root to log in to the operating system.
localhost login: root
Password:
Last login: Fri May 20 16:38:18 on ttyS0
[root@localhost ~]#
9. Execute the poweroff command. Power off the router at the prompt acpi_power_off called.
[root@localhost ~]# poweroff
Broadcast message from root Stopping sshd: [ OK ]
Stopping acseic-daemon: [ OK ]
Shutting down SMB services: [ OK ]