H3C Technologies H3C MSR 50 User Manual
Page 12
6
Hard Disk Size : 500.1GB
Press Ctrl+D to enter BIOS Menu...
2.
Press Ctrl + D at the prompt to enter the BIOS menu.
===============
| <1> Boot from NAND Flash |
| <2> Boot from Hard Disk |
| <3> Boot from USB |
| <4> Boot from Ethernet |
| <5> Default boot device |
| <0> Reboot |
==============================================================
Enter your choice(0-5):
3.
Select 4 to enter the submenu.
Enter your choice(0-5):4
===============
| <1> Eth0 |
| <2> Eth1 |
| <0> Exit |
==============================================================
Enter your choice(0-2):
4.
Select 2 to start network installation.
Enter your choice(0-2):2
Reading boot sector...Done
Switching to boot loader
…
udhcpc (v1.17.3) started
Setting IP address 0.0.0.0 on eth1
Sending discover...
Sending discover...
Sending select for 192.168.0.250...
Lease of 192.168.0.250 obtained, lease time 21600
Setting IP address 192.168.0.250 on eth1
Recreating /etc/resolv.conf
Please press Enter to activate this console.
5.
Press Enter at the prompt.
BusyBox v1.17.3 (2011-02-12 09:08:53 CST) built-in shell (ash)
Enter 'help' for a list of built-in commands.
/ #
6.
Execute the pxe_install mim-oaps-v2 all command to start installing the software.
Use the pxe_install mim-oap-v2 all command for a MIM-OAP module. Use the pxe_install
fic-oap-v2 all command for a FIC-OAP module.
[root@localhost /root]#pxe_install mim-oaps-v2 all
Adjust system time...Ok
Get install script file...Ok