H3C Technologies H3C MSR 5600 - Manual (Page 20)

13
Step Command Remarks
12. (Optional.) Specify the
backup POS application
template. backup app app-id
By default, no backup POS application
template is specified.
This command is applicable only to
TCP-based POS application templates. If
the specified application template does
not exist or is not TCP type, the command
can be configured but it does not take
effect.
13. (Optional.) Set the quiet
timer.
timer quiet interval
By default, the quiet time is 600 minutes.
This command is applicable only to
TCP-based POS application templates.
The change on the quite timer takes effect
immediately. The new timer starts from
the beginning for an FEP in blocked state.
14. (Optional.) Enable the POS
application template
handshaking.
hello enable
By default, POS application template
handshaking is disabled.
15. (Optional.) Set the interval
time for the handshaking
packet
timer hello interval By default, the interval is 1 minute.
16. Return to system view. quit N/A
17. Enter interface view.
interface interface-type
interface-number
The interface can be an asynchronous
interface, or a
synchronous/asynchronous interface.
18. (Optional.) Bind the POS
application template to the
interface.
posa bind app app-id
By default, no POS application template
is bound to the interface.
This configuration is required for the POS
application in flow mode.
Configuring the POS application mapping table
Follow these guidelines when you configure the POS application mapping table:
• One application template can correspond to multiple mapping entries.
• The entry that has both the originator and destination addresses has the highest priority. The default
entry has the lowest priority.
• The device supports up to 1024 POS application mapping entries.
• Changing the destination FEP of a mapping entry during the transaction will not remove the
connection in use, but it might affect the ongoing POS transaction.
To configure a POS application mapping entry:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure a POS application
mapping entry.
posa map { { destination
des-code | source src-code } *
| default } app app-id
By default, no mapping entry
exists.