H3C Technologies H3C SR6600-X - Manual (Page 42)

34
NOTE:
•
The MIM-8E1(75)/MIM-8E1(75)-F does not support ISDN PRI.
• For the MIM-8E1(75), if you use the timeslot binding command on the controller E1 interface, the
system automatically creates a serial interface, on which the configuration takes effect. The
MIM-8E1(75)-F does not have any controller E1 interfaces, and a physical interface corresponds to one
and only one serial interface, which is automatically created without the need of additional
configuration.
• For the appearance and connection of a MIM-8E1(75)/MIM-8E1(75)-F interface cable, see
"
Connecting an E1 interface cable ."
MIM-8T1/MIM-8T1-F RT-MIM-8T1-H3)/MIM-8T1-F
(RT-MIM-8T1-F-H3)
The MIM-8T1 is an 8-port channelized T1 interface module, which transmits, receives, and processes
eight channels of T1 data, and supports CT1 access.
The MIM-8T1-F is an 8-port non-channelized T1 interface module. It differs from the MIM-8T1 in these
ways:
• The FT1 operating mode supported by the MIM-8T1-F allows only one n × 64 kbps OR 56 kbps
bundle to be formed on each interface, where n is in the range 1 to 24.
• The MIM-8T1 allows arbitrary grouping of 24 channels and thereby multiple bundles.
Front panels
Figure 25 Front panel of MIM-8T1
(1) DB-68 connector (2) Carrier signal LED (LINK/ACT)
(3) Captive screw (4) Loopback/Alarm LED (LP/AL)
Figure 26 Front panel of MIM-8T1-F
The front panel of the MIM-8T1-F is similar to that of the MIM-8T1.