H3C Technologies H3C SR6600-X - Manual (Page 31)

23
Item Specification
Receiving sensitivity –30.0 dBm –28.0 dBm –34.0 dBm –34.0 dBm
Overload optical power –14.0 dBm –7.0 dBm –9.0 dBm –10.0 dBm
Central wavelength 1310 nm 1310 nm 1310 nm 1550 nm
Max. transmission distance 2 km (1.24 miles)
15 km (9.32
miles) 40 km (24.86
miles) 80 km (49.71
miles)
Fiber type
62.5/125 μm
multi-mode 9/125 μm
single-mode 9/125 μm
single-mode 9/125 μm
single-mode
The Ethernet fiber ports of the HIM-4G4P support 1000 Mbps SFP fiber transceiver modules 1000 Mbps
SFP copper transceiver modules, and the POS interfaces support 155 Mbps SFP fiber transceiver
modules.
The transceiver modules are optional.
Interface cables
The HIM-4G4P is used together with SFP transceiver modules and fibers with LC connectors.
For the appearance and connection of a HIM-4G4P interface cable, see "
Connecting an optical
interface cable ."
HIM-TS8P (RT-HIM-TS8P-H3)
The HIM-TS8P provides 8 ports, each of which can be switched between a POS interface and an Ethernet
port. A POS interface transmits data at OC-3/STM-1 (155.52Mbps) or OC-12/STM-4 (622Mbps). An
Ethernet port transmits data at 1000 Mbps. The HIM-TS8P is half the height of a HIM, and occupies one
slot on a FIP.
To switch the interface type of a HIM-TS8P, use the port-type switch command.
To switch the POS interface speed of a HIM-TS8P, use the speed command in POS interface view.
For more information about the port-type switch and speed commands, see H3C SR6600/SR6600-X
Routers Interface Command Reference.
Front panel
Figure 18 Front panel
(1) Captive screw (2) SFP port
(3) Ejector lever (4) SFP port carrier signal LED (LINK/ACT)