H3C Technologies H3C SR6600-X - Manual (Page 35)

27
Item Specification
Receiving sensitivity –17 dBm –20 dBm –23 dBm –21 dBm –22 dBm
Central wavelength 850 nm 1310 nm 1310 nm 1550 nm 1550 nm
Max. transmission distance
0.55 km
(0.34 miles) 10 km (6.21
miles) 40 km
(24.86 miles)
40 km
(24.86
miles)
70 km (43.50
miles)
Fiber type
62.5/125
μm
multi-mode
9/125 μm
single-mode 9/125 μm
single-mode
9/125 μm
single-mod
e
9/125 μm
single-mode
Transmission rate • 100/1000 Mbps, half/full duplex
The following transceiver modules are available for the HIM-8GBP-V2:
• 100 Mbps fiber SFP transceiver modules.
• 1000 Mbps fiber SFP transceiver modules.
• 100/1000 Mbps fiber SFP transceiver modules.
• 10/100/1000 Mbps copper SFP transceiver modules (support for 10/100/1000 Mbps
autosensing on the HIM-8GBP-V2).
Prepare the transceiver modules yourself as required.
H3C recommends that you use H3C SFP transceiver modules for the device. H3C does not guarantee the
compatibility of SFP transceiver modules from other vendors with the device. The device reports an alarm
when non-H3C SFP transceiver modules are installed.
Interface cables
Use interface cables for the HIM-8GBP-V2 as follows:
• Fiber SFP transceiver module—Fibers with the LC connector.
• Copper SFP transceiver module—Category-5 straight-through or crossover twisted pair cable when
the port is operating at 10/100 Mbps and Category-6 twisted pair cable when the port is
operating at 1000 Mbps.
For the appearance and connection of the interface cables, see " Connecting an Ethernet interface
cable " and " Connecting an optical interface cable ."
HIM-16GBP
The HIM-16GBP high-speed Layer 3 GE interface module provides 16 SFP ports. These SFP ports support
Layer 3 routing.