Connecting the power cord, Connecting an ac power cord – H3C Technologies H3C S5800 Series Switches User Manual
Page 14
10
2.
Switch off the power module and disconnect the power cord.
3.
Loosen the captive screw on the power module with a Phillips
screwdriver until the captive screws are completely disengaged
from the device.
4.
Grasp the handle of the module with one hand and pull the
module outwards. After the power module is pulled part way out,
hold the module bottom with the other hand, and pull the module
slowly along the guide rails out of the slot.
5.
Put the removed power module into an antistatic bag
Connecting the power cord
After you install a power module on a device, you can connect the
power cord. Use an AC power cord to connect the AC-powered device
to the AC power source. Use a DC power cord to connect the
DC-powered device to the DC power source.
Connecting an AC power cord
1.
Switch off the AC power module.
2.
Pull the bail latch upwards, as shown in
3.
Connect one end of the AC power cord to the AC receptacle on
the module, as shown by callout 1 in
.
4.
Pull the bail latch down to secure the plug to the AC receptacle, as
shown in callout 2 in
5.
Connect the other end of the AC power cord to the AC power
source.