H3C Technologies H3C S6300 Series Switches - Manual (Page 15)

8
Step Command Remarks
5. Enable TRILL on the
port.
trill enable By default, TRILL is disabled on a port.
Configuring the system ID and nickname for an RB
The system ID and nickname of an RB are identifiers of the RB in the TRILL network.
• System ID—Unique identifier of an RB in the TRILL network. The system ID can be automatically
assigned or manually configured.
• Nickname—Address of an RB in the TRILL network. The address can be automatically assigned or
manually configured. When multiple RBs in the TRILL network have the same nickname, the RB with
the highest priority uses the nickname. When RBs have the same priority, the RB with the highest
system ID uses the nickname. The system automatically assigns new nicknames to the other RBs.
If you set a new different system ID for an RB, the system resets the TRILL process.
To configure the system ID and nickname for an RB:
Step Command Remarks
6. Enter system view. system-view N/A
7. Enter TRILL view. trill N/A
8. Configure the system
ID for the RB.
system-id system-id
By default, an RB automatically generates a
system ID according to its MAC address
upon startup.
9. Configure the
nickname for the RB.
nickname nickname [ priority
priority ]
By default, the system automatically assigns
nicknames to RBs, and the priority for a RB
to hold a nickname is 64.
Configuring the link type of a TRILL port
The following link types are available for a TRILL port:
• Access—Access ports include access ports without the alone attribute and access ports with the
alone attribute. Access ports with the alone attribute do not send or receive Hello frames and do not
participate in the DRB election or AVF negotiation. Access ports without the alone attribute can
process only local data frames and Hello frames.
• Hybrid—A hybrid port combines the attributes of an access port and a trunk port, and can process
local data frames and passing data frames.
• Trunk—A trunk port can process passing data frames and some of Layer 2 protocol frames (for
example, LLDP frames), but it cannot process local data frames.
To configure the link type of a TRILL port:
Step Command Remarks
1. Enter system view. system-view N/A