H3C Technologies H3C S12500 Series Switches - Manual (Page 16)

9
Step Command Remarks
3. Configure the maximum
number of flow entries that
each extensibility flow table
supports.
flow-entry max-limit limit-value
The default value for the limit-value
depends on the card model and
the ACL hardware mode. For more
information about the ACL
hardware mode, see ACL and
QoS Configuration Guide.
Configuring inband management VLANs
By default, an OpenFlow instance that is associated with VLANs establishes connections with controllers
only through ports that are not assigned to these VLANs. You can configure one or more of these
associated VLANs as inband management VLANs for an OpenFlow instance. Then, the OpenFlow
instance establishes connections with controllers through ports that are assigned to the inband
management VLANs.
Traffic in inband management VLANs are forwarded in the normal process instead of the OpenFlow
process. The ports that are assigned only to inband management VLANs are not OpenFlow instance
ports.
To configure inband management VLANs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OpenFlow instance
view.
openflow instance instance-id N/A
3. Configure the inband
management VLAN. in-band management vlan { vlan-id
[ to vlan-id ] } &<1-10>
By default, no inband management
VLAN is configured for an
OpenFlow instance.
Inband management VLANs that
you configure for an OpenFlow
instance must be within the list of
the VLANs that are associated with
the OpenFlow instance.
Configuring OpenFlow to forbid MAC learning
You can configure this feature for an OpenFlow instance to forbid MAC learning for VLANs that are
associated with the OpenFlow instance.
To configure OpenFlow to forbid MAC learning:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OpenFlow instance
view.
openflow instance instance-id N/A