Enabling selective flooding for a mac address, Displaying and maintaining evi, Configuring an evi is-is process – H3C Technologies H3C S12500 Series Switches User Manual
Page 26

19
Step Command
Remarks
4.
(Optional.) Display EVI ARP
flooding suppression entries.
•
In standalone mode:
display evi arp-suppression
interface tunnel
interface-number [ vlan
vlan-id ] [ slot slot-number ]
[ count ]
•
In IRF mode:
display evi arp-suppression
interface tunnel
interface-number [ vlan
vlan-id ] [ chassis
chassis-number slot
slot-number ] [ count ]
The display commands are
available in any view.
Enabling selective flooding for a MAC address
CAUTION:
Do not configure selective flooding for a unicast MAC address that might be learned at an edge device's
data plane. The configuration can cause packets destined for the MAC address to be dropped on remote
devices after they get the MAC address through EVI IS-IS.
An edge device by default floods unknown unicast and multicast frames only to internal interfaces.
If an application uses a special multicast address that requires flooding across sites and cannot be
added to a multicast forwarding table by IGMP snooping, enable selective flooding for it.
To enable selective flooding for a MAC address:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter tunnel interface view.
interface tunnel number [ mode evi ] N/A
3.
Enable selective flooding for
the MAC address in a set of
VLANs.
evi selective-flooding mac-address
mac-address vlan vlan-id-list
By default, selective flooding is
disabled for all MAC addresses.
Displaying and maintaining EVI
Execute display commands in any view and reset commands in user view.
Task Command
On an ENDS, display IPv4 ENDS
information (on an ENDS).
display evi neighbor-discovery server summary
On an ENDS, display IPv4 neighbors
that have registered with the ENDS.
display evi neighbor-discovery server member [ interface tunnel
interface-number | local local-ip | remote client-ip ]
On an ENDS, display ENDS statistics.
display evi neighbor-discovery server statistics interface tunnel
interface-number