H3C Technologies H3C S12500 Series Switches - Manual (Page 25)

18
Step Command Remarks
4. Configure the restart interval.
graceful-restart interval
interval-value
The default restart interval is 300
seconds.
If the restarting EVI process fails to
complete re-establishing the adjacency
with the peer EVI process, the EVI link
goes down.
Increasing the maximum number of MAC entries in an LSP for
an EVI IS-IS process
An EVI IS-IS process advertises all local MAC reachability information in one LSP. By default, an LSP can
convey up to 55 x 2 10 MAC address entries.
To increase this number to accommodate all local MAC address entries, create virtual systems. Each
virtual system represents an increase of 55 x 2 10 MAC reachability information entries. If n virtual systems
are created, the maximum number of MAC address entries in an LSP is (n+1) x 55 x 2 10 .
To configure EVI IS-IS virtual system:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter EVI IS-IS process view. evi-isis process-id N/A
3. Create an EVI IS-IS virtual
system.
virtual-system systemid
By default, no EVI IS-IS virtual systems are
created.
IMPORTANT:
The virtual system ID must be unique in the
EVI network.
Enabling EVI ARP flooding suppression
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter tunnel interface view.
interface tunnel number [ mode
evi ]
N/A
3. Enable EVI ARP flooding
suppression.
evi arp-suppression enable
By default, EVI ARP flooding
suppression is disabled.