H3C Technologies H3C S12500 Series Switches - Manual (Page 2)

2
Figure 1 Grounding the ESD wrist strap
Installing a transceiver module
CAUTION:
•
When installing or removing a transceiver module, avoid
touching the golden plating on the transceiver module with a bare
hand.
• Do not remove the dust plug from a transceiver module if you are
not to connect an optical fiber to it.
• Remove the optical fibers, if any, from the transceiver module
before installing it.
To install a transceiver module:
1. Pivot the clasp of the transceiver module up so that it catches a
knob on the top of the transceiver module.
2. Holding both sides of the transceiver module, gently push the
transceiver module into the socket until it makes firm contact with