Ensemble Designs 5420 SD Logo Inserter - Manual (Page 11)

MODULE CONFIGURATION AND CONTROL
The configuration parameters for each Avenue module must be selected after installation.
This can be done remotely using one of the Avenue remote control options. This module
has no local front panel configuration controls. The REMOTE/LOCAL switch on the front
edge of the circuit board which should be set to the REMOTE mode.
The 5420 Parameter Table on the following page summarizes the various configuration
parameters that can be set remotely and the default/factory settings.
Avenue module parameters can be configured and controlled remotely from one or both of
the remote control options, the Avenue Touch Screen or the Avenue PC Application. Once
the module parameters have been set remotely, the information is stored on the module
CPU. This allows the module be moved to a different cell in the frame at your discretion
without losing the stored information. Remote configuration will override whatever the
switch settings are on the front edge of the module.
For setting the parameters using the Avenue PC option, refer to the Avenue PC Remote
Configuration section of this document.
For setting the parameters using the Avenue Touch Screen option, refer to the Avenue
Touch Screen operating section in the Avenue System Overview section.
Model 5420 Digital Logo Inserter
5420-11