Amped Wireless UA600EX - High Power Wireless-N 600mW Pro USB Adapter - Manual (Page 55)

UA600EX USER’S GUIDE
54
e. Uninstall the software by clicking Start, then select Control Panel, then select Programs. Find the
Amped Wireless program and uninstall it. Once fully uninstalled, remove the adapter from your USB
port, reinstall the Amped Wireless software using the supplied instructions and try again.
The adapter is installed and plugged in and I cannot access the Internet.
a. You may have a mismatch in your SSID or your wireless security key. Double check the security key
that you are using for your current wireless connection. Double check that the name of the SSID is
the correct name of the network you are trying to connect to.
b. You may have an incorrect IP address assignment.

For Windows XP and 2000: Open the Amped Wireless Utility and go to the General tab. Click
Renew IP.

For Windows 7 and Vista: Open the Windows wireless utility by clicking the wireless icon on the
bottom right corner. Right click the wireless network that you are connected to and click Status.
Click diagnose to allow Windows to reset your connection.

For Mac OS X: Open the Amped Wireless Utility and disconnect from your current network. Wait
a few moments and connect again. If this does not work, unplug the USB adapter from your Mac
and plug it back in. Connect to your network again and check your Internet connection.