AML M2800 - Manual (Page 6)

Model M2800 USB Bar Code and Magnetic Card Reader
Page: 6
©2005 American Microsystems, Ltd. All Rights Reserved
2190 Regal Parkway • Euless, TX 76040
Phone 817.571.9015 • Fax 817.571.6176
Web Address: www.amltd.com
DEFAULT SETTINGS
The M2800 is shipped from the factory with the following default settings:
Code 39
UPC
Code 39 Decoder ON UPC Decoder ON
Full ASCII OFF Convert UPC-E to UPC-A OFF
Mod 43 Check Digit OFF Convert UPC-A to EAN-13 OFF
Send Check Digit OFF Send UPC-A Number System ON
Concatenate Mode OFF Send UPC-E Number System ON
Send UPC-A Check Digit ON
Send UPC-E Check Digit ON
EAN
UPC/EAN SUPPLEMENTS
EAN Decoder ON Supplements Decoder OFF
Zero Fill EAN-8 to EAN-13 OFF Allow 2 Digit Supplements ON
Send EAN-13 Country Code ON Allow 5 Digit Supplements ON
Send EAN-8 Country Code ON Require Supplements None
Send EAN-13 Check Digit ON Send Separator Space OFF
Send EAN-8 Check Digit ON
ISBN Conversion OFF
INTERLEAVED 2 of 5
CODABAR
I 2 of 5 Decoder ON Codabar Decoder ON
Check Digit None Send Start/Stop OFF
Send Check Digit OFF CLSI Formatting OFF
Fixed Length OFF CLSI Check Digit OFF
Set Fixed Length #1 06
Set Fixed Length #2 00
CODE 93
RSS SYMBOLOGIES
Code 93 Decoder ON RSS14 Decoder ON
Concatenate Mode OFF RSS Limited Decoder OFF
RSS Expanded OFF
CODE 128 Send EAN Type Identifier OFF
Code 128 Decoder ON Send Application ID (AI) ON
UCC-128 Verification OFF Send Linkage ID OFF
Send Mod 10 Check Digit ON Send Check Digit ON
MSI/PLESSEY
CODE 11
MSI/Plessey Decoder OFF Code 11 Decoder OFF
Two Check Digits Required OFF Two Check Digits Required OFF
First Check Digit Mod 11 OFF Send 1
st
Check Digit OFF
Send 1
st
Check Digit OFF Send 2
nd
Check Digit OFF
Send 2
nd
Check Digit OFF
ISBN Plessey OFF
PREAMBLE
POSTAMBLE
Enter Preamble OFF Enter Preamble OFF
Preamble Send Delay 0.0 sec Postamble Send Delay 0.0 sec
Active Types ALL Active Types ALL