AML M2800 - Manual (Page 19)

Model M2800 USB Bar Code and Magnetic Card Reader
Page: 19
©2005 American Microsystems, Ltd. All Rights Reserved
2190 Regal Parkway • Euless, TX 76040
Phone 817.571.9015 • Fax 817.571.6176
Web Address: www.amltd.com
TERMINATION CHARACTER
The optional Termination Character is transmitted at the end of the data. If a user defined Termination Character
is desired select option 4 below, then scan a single character from the Full ASCII section of the Setup Menu.
0) None
1)
Horizontal Tab (ASCII 09) or (Special Keys On: USB Tab Key)
2)* Carriage Return (ASCII 13) or (Special Keys On: USB Enter Key)
3) USB Numeric Keypad Enter
4) User Defined Termination Character (from ASCII chart)
SCAN BEEP
Settings (0-3) set the length of the beep. Settings (4-7) set the tone (pitch) of the beep. Setting (8), when selected
will override the other beep selections and shut the beep off.
Length
Tone
0) Short 4) Low
1) * Medium Short 5) Medium Low
2) Medium Long 6)* Medium High
3) Long 7) High
8) No Beep
BAR CODE EDIT
This option allows data editing (modification) before transmission.
0) DATA EDITING
Must be on for any of the editing options below to be valid.
ON:
Enable Data Editing.
OFF*: Disable Data Editing.
1) ENTER # OF LEADING CHAR TO STRIP (0-9, A-F)
Refers to the number (0-15) of characters to be stripped or removed from the beginning of the bar code
data.
2) ENTER # OF TRAILING CHAR TO STRIP (0-9, A-F)
Refers to the number (0-15) of characters to be stripped or removed from the end of the bar code data.
NOTE: If the total number of strip characters (both Leading and Trailing) is greater than the number of
characters of the bar code, no characters will be stripped.
3) ENTER DATA TYPE TO EDIT
Refers to the type of bar codes for which editing can be enabled, allowing editing to be specific to a type
of bar code. The choices are listed below:
A Code 39 E EAN-8 I Code 93 M RSS14
B UPC-A F I 2 of 5 J MSI/Plessey N RSS Limited
C UPC-E G Codabar K Code 11 O RSS Expanded
D EAN-13 H Code 128 L ISBN X* All Bar Codes
4) STRIP LEADING & TRAILING SPACES
ON: Any Leading and Trailing Spaces will be stripped from the data.
OFF*: No spaces will be stripped.