Amer Networks WLO220T - Manual (Page 14)

14
Network
Configure the WLO Ipv4 address settings. This will include the static routes and the
DNS servers uses by the WLO.
Interface Table
Modify or configure the IPv4 settings for all the interfaces on the WLO.
For management access to the device, use BR0 for the WLO220T, and ETH2 for the
WLO880T and WLO880F. By default ETH0 and ETH1 are in transparent mode, so no
configuration is required.
Add logical interface allows for more interfaces to be created on the WLO.
Add bridge interface allows for another bridge interface to be created.
Both of these options are for troubleshooting purposes they are not needed in
normal operations of the WLO.
Select the management interface by clicking on BR0 or ETH2.
Modify the IPv4 address for access to the WLO.
Set the management access protocol used to access the WLO.
The link connection speed will also be listed here, and can be modified to better suit
your network environment. The ability to down the interface is also listed.