Allstar Performance ALL96510 - Manual

Allstar Performance 8300 Lane Drive, Watervliet MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
FORM 1013 Rev.8/06
Spark Plug Indexing Tool
Proper indexing positions the ground strap of the spark plug properly for best piston dome clearance and
unshrouds the electrode for a more even burn and possible gains of 5-15 horsepower. Works with fl at gasket
or taper seat 14mm spark plugs
1. Torque a spark plug to proper specifi cation into cylinder #1.
2. With a fi ne line marker, draw a line on the plug porcelain at the 12 o’clock position.
3. Remove spark plug from cylinder head.
4. Torque the spark plug into the tool with the clock numbers facing you.
5. Record the clock number that the marker line points at and which cylinder you are indexing.
6. Remove the plug from the indexing tool, and wipe off the marker line.
7. Proceed to the remaining cylinders, repeating procedure.
8. Your list should end up looking similar to this:
9. Take a fresh box of spark plugs and torque each one into the tool. Note which clock number the ground
strap on the plug lines up with. In the example list above if the strap lines up with #6 on the wrench it
will index properly in cylinder #1. It may take as many as 20 spark plugs to perfectly index a set for an 8
cylinder. Normally it will not hurt performance if plugs are plus or minus one o’clock number. Plugs that
do not index properly using the factory supplied crush washer are saved for the next motor, as every
head is diff erent.
10. With the clock numbers recorded for each cylinder you can now index plugs for your performance or
race engine (or engines) at your own convenience.
Cylinder Number Clock Number
1 6
3 9
5 10
7 1:30
2 5
4 8
6 5
8 3:30