Allstar Performance ALL48200-04 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1012 Page 1 of 1 Rev. 070113
INSTRUCTIONS
Power Steering Hose Kits
WARNING!
Clean inside of hose after cutting.
Small metal and rubber particles will
damage pump and gearbox.
Step 1 Step 2 Step 3 Step 4
Steering Box Fittings (Sold Separately)
Part No. Description
ALL48210 ......................-6AN Male To 16mm With O-Ring
ALL48211 ......................-6AN Male To 14mm With O-Ring
ALL48212 ......................-6AN Male To 18mm With O-Ring
ALL48215 ......................-6AN Male To 5/8"-18 Without O-Ring
ALL48217 ......................-6AN Male To 11/16"-18 Without O-Ring
Connect -10AN hose (A) on tank to (A) on pump. Connect
the -6AN pressure line (B) on pump to the smallest fitting on
the steering box. Connect return line from large fitting on the
steering box to (C) on the tank.
Cut hose square with fine
tooth hacksaw or cut off
wheel.
Put socket in vise and rotate
hose counterclockwise into
socket until it bottoms, then
back off 1/4 turn. When
assembling long lengths
of hose put the hose in
vise just tight enough
to prevent turning and
turn socket into the hose
counterclockwise until it
bottoms.
Lubricate nipple and threads
LIBERALLY. Use heavy oil or
hose assembly lube.
Thread nipple clockwise into
socket and hose. Leave 1/32"
to 1/16" clearance between
nipple hex and socket.
Typical GM 800 Series
Steering Box Connection
From Pump
To Tank
A
B
A
C