beautypg.com

Allstar Performance ALL48015 User Manual

Electric brake shut-off instructions instructions

background image

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098

Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com

Form 1038

Page 1 of 1

Rev. 112111

Outlet Port

Inlet Port

Master Cylinder

To LF Brake
Assembly

ALLSTAR

3 Wheel

Brake

Switch

Red ("+")

Black ("-")

To RF Brake
Assembly

1. Test unit before installation to assure proper operation. Connect red wire to a 12v (+) source and the

black wire to a 12v (-) source, unit should cycle letting you know spool valve inside is free and

functioning properly. Proper operation is noted by an audible click when power is applied and released.

2. Securely mount control valve to a panel or bracket in a location that provides easy connections to the

right front brake line. Control valve can be mounted in any position.

3. Use thread sealer or tape when installing fittings into valve. Use caution to prevent contamination

of sealer entering valve.

4. Install one of the included 3/16" inverted flare fitting into one of the inlet port, see diagram.

5. Install the remaining 3/16” inverted flare fitting into the outlet port of the valve, see diagram.

6. Connect the brake line from the master cylinder to the inlet port of the valve. If you have a tee fitting to

the front brakes, make certain valve is plumbed after the fitting. See diagram.

7. Connect the brake line from the right front brake to the outlet port of the valve.

8. Bleed system.

9. Once valve has been mounted and connected, remove top retaining nut and apply a small amount of

blue thread locker and reassemble hand tight. Overtightening of this nut will damage the internal valve.

10. Connect the black wire from the valve to a reliable chassis ground.

11. Connect the red wire to a single pole switch (ALL99067) located within easy reach of the driver. Switch

needs to be returned to 4 wheel brakes when not in use. CAUTION: If switch is left on for an extended

period of time damage to solenoid will result. It is recommended to connect the 3 wheel brake switch to

a separate switched power source to prevent damage.

Contents List:
Electronic Shut-Off Valve (x1)
1/8" NPT To 3/16" Inverted Flare Fittings (x2)

Electric Brake Shut-Off Instructions

INSTRuCTIONS

To 12V "+"

Power

Source