Allmand Brothers NL PRO II - Manual (Page 38)

38
OPERATION
Installing the Ground rod
The ground rod is a safety device that may
reduce the chance of personal injury from
stray electrical current. Therefore, Allmand
recommends using the ground rod. However,
it is the user’s responsibility to determine the
requirements and/or applicability of local,
state or national electrical code which governs
the use of the ground rod.
Drive the ground rod fully into the ground us-
ing a hammer. Attach the supplied cable to
the rod and then attach the cable to the
ground lug on the unit. Make sure the cable
connections are tightened.
ENGINE OPERATION
Before starting the engine or operating the
light tower, review Safety on page 8.
The Allmand NIGHT LITE PRO II Series
light towers are powered by a diesel engine
and generator unit.
Pre - Start Checks
1. Check the engine oil and add oil if re-
quired. Fill the engine with the proper
grade of lubricating oil; refer to the Engine
Operator’s Manual for oil specifications.
2. Check and add diesel fuel as required.
3. Ensure that the air cleaner is firmly at-
tached and air cleaner seals and hose
clamps are properly sealed. Air cleaner
element should be checked and replaced
if necessary.