Operation – Allmand Brothers NL PRO II User Manual
Page 37
37
OPERATION
OPERATION
Physically inspect the machine for damage
and repair if necessary.
Leveling and Stabilizing the Trailer
WARNING! ROLLOVER HAZARD. Do not
set up on unlevel ground. Only set up on
smooth, flat and solid ground surfaces. Al-
ways level the light tower trailer before
raising the light tower.
The NIGHT LITE PRO II must be leveled to 5
˚
or less, front-to-back and side-to -side.
1. Position NIGHT LITE PRO II on an ade-
quate site; see Work Site Safety Considera-
tions on page 36.
2.
Block each wheel on each side with a
suitable wheel chock (Figure 8,1).
3. Extend the front outrigger stabilizers out
and lock in place (Figure 9).
4. Rotate each rear stabilizer jack perpen-
dicular with the ground and lock in place.
5. Adjust each rear stabilizer jack and the
tongue jack to achieve proper leveling.
Turning the handles clockwise will raise
the jacks, and counterclockwise will lower
the jacks.
WARNING! Rollover Hazard. All stabilizer
jacks must be supported by a flat, level solid
ground surface.
1. Outrigger Lock Pin - Locks outrigger in po-
sition.
2. Jack Handle (front) - Used to raise or lower
outrigger jack.
3. Jack Pin - Locks jack in position to prevent
jack from rotating.
1. Tongue Jack Handle - Used to raise or
lower tongue jack.
1
Figure 8
Figure 9
1
2
3
Figure 10
1