Allmand Brothers NL PRO II - Manual (Page 19)

19
TRAILERING, TRANSPORTING AND LIFTING
Vertical Tower Lights - Stowage for Trailering
The light bar and fixtures must be stowed before trailering or transporting.
WARNING! Burn Hazard. The light fixtures become extremely hot during use.
Always use caution and heat - resistant gloves when handling the
Lights or allow to the lights to sufficiently cool down before
handling.
1. Ensure lights are off and tower is lowered to the full DOWN position; see Raising and lowering the
light Tower on page 44-45.
2. Release the light bar park pin by pulling the ring and turning it 90 degrees so that the pin remains
in the retracted position.
3. Rotate the light bar into the trailering / transport park position (in line with trailer) and engage the
park pin by twisting the park pin ring until the plunger is released and the pin engages and locks
into the hole in the light bar.
4. Reposition the light fixtures for trailering / transport by pulling them down into the lowest position
and face the fixtures toward the center of the trailer. (see below)
NOTE: If lights are to be removed for trailering / transporting, see Tower Llghts - Removal for
trailering / transporting (Optional) on page 21.