Alinco DJ-500 - Manual (Page 38)

22
ADVANCED OPERATIONS
Frequency Reverse
In standby state, press key, the top left corner of LCD displays " " icon, then press to set the
current channel to Reverse function, Repeat the operations to cancel channel Reverse function.
1. When LCD displays "
R" icon, it means current arrow directed channel open the
frequency reverse function, the TX frequency and RX frequency is interchanged, if
CTCSS/DCS signaling is set, it will also interchange.
2. When " R" icon disappears, it means reverse function is close.
TX Power selection
In standby state, press key, the top left corner of LCD displays " " icon, then
press key to choose High/Low power for current arrow directed channel.
L: Power is 1W.
M: Power is 2.5W.
H: Power is 5W.
Stopwatch function
1. In standby state, press key, the top left corner of LCD displays " " icon, then
press to enter into stopwatch function.
2. Press key to start timing. Under this state, press key to pause timing.
When timing is pause, press key to continue timing.
3. Press [PF1], [PF2] or key to exit stop watch function.