Alinco DJ-500 - Manual (Page 32)

16
BASIC OPERATIONS
NOTE: Please be aware of the squelch level and selective-calling settings such as CTCSS and DCS as you
may risk not hearing the receiving signal.
Transmitting
1. Select the frequency by using the dial or keypad.
2. Press the PTT key. The red TX indicator turns on while transmitting.
3. While holding down the PTT key, speak into the unit at normal voice from the distance of 5cm (2").
4. Release the PTT key to receive.
Before transmitting, it is recommended to monitor the channel you are going to use to ensure it is not
busy by pressing and holding [PF2] key.
Alarm
Press and hold alarm key until LCD displays "ALARM", Emergency alarm function is started. This
transceiver has 4 Alarm modes for optional, can be setup in programming software. Power off transceiver
to exit Alarm.
Side Key【PF1】function
The Side [PF1] key can realized functions as below:
1.In receiving mode, press to check current voltage.
NOTE: Please use programming software to choose the Alarm mode or close Alarm.