Airmar 200WX—Ultrasonic WeatherStation® Instrument - Manual (Page 20)

20
Humidity Sensor: 110WX, 150WX, 200WX
1. Remove the two screws from the humidity sensor or blank (see Figure 11).
2. Remove the sensor or blank.
3. Push the new humidity sensor into place. Fasten it with the two screws
supplied. Using a torque wrench, apply 0.25 - 0.30Nm. Do not over tighten.
Software
Revisions
Airmar may release updated versions of both the WeatherStation firmware and the
WeatherCaster™ software. Periodically check Airmar’s website at www.airmar.com
to down-load the latest revision or contact Technical Support for a CD.
Installing WeatherCaster™ Software
Follow the instructions in the WeatherCaster Software Guide.
Figure 11. Replacing the humidity sensor
screws
humidity
sensor
Copyright © 2011 Airmar Technology Corp.