Airmar 200WX—Ultrasonic WeatherStation® Instrument - Manual (Page 19)

19
Maintenance
CAUTION: Do not disassemble the WeatherStation Instrument. There are no
user-serviceable parts inside. Removing the three screws holding the lower
housing will damage the waterproof seal, voiding the warranty.
CAUTION: Do not immerse in water or pressure wash. Doing so may allow water
to infiltrate the WeatherStation Instrument, voiding the warranty.
CAUTION: The reflector plate and the waterproof film found in the wind channel of
the WeatherStation Instrument are essential to its operation. The waterproof film
protects the transducers, so be careful to keep it intact. Do not to scratch the
reflector plate or damage it in any way.
CAUTION: Avoid damaging the rain sensor. If the umbrella becomes chipped or
cracked, readings from the sensor may be incorrect. If the umbrella does become
damaged, return the WeatherStation Instrument to the factory to replace the
umbrella and re-calibrate the rain sensor.
IMPORTANT: Keep the wind channel free of SPIDER WEBS, insects, dirt, and
other debris. Keep the temperature and humidity sensors clean.
Cleaning
Since the WeatherStation Instrument has no moving parts, it requires minimal
maintenance. Clean with a damp cloth and mild household detergent (see Figure 10).
Gently thread an alcohol wipe through the wind channel to remove spider webs and
any debris.
Figure 10. Maintenance (200WXR shown)
reflector plate
waterproof film
wind channel
temperature sensor
humidity sensor
rain sensor
serial number
lower housing
screw (3)
Copyright © 2008 - 2011 Airmar Technology Corp.