Airlink AML001 - Manual (Page 65)

PCI Modem Card User's Manual
64
+FTS= causes the modem to terminate a transmission and wait for
x 10 ms before responding with the OK result code. For example,
= 5 results in a 50 ms interval. has a range of 0—255.
A.2 Result Codes
The soft modem AT command handler responds to commands from the
caller and to activity on the line via result codes. Table below presents a
summary of these result codes.
Two forms of each result code are available. The long-form, or verbose,
response is given when V1 is selected, and the short-form, numeric response
is given when V0 is selected. The long-form code is preceded and terminated
by the sequence . The short-form is also terminated by ,
but it has no preceding sequence. If result codes are suppressed, nothing is
returned to the caller.
Result Code Numeric
Code Description
OK 0 Acknowledges the execution of a
command line.
CONNECT 1 Modem connected to line.
RING 2 Incoming ring signal has been
detected.
NO CARRIER 3 Modem lost carrier signal, does not
detect carrier signal, or does not
detect answer tone.
ERROR 4 Invalid command.
CONNECT 1200 EC* 5 Connection at 1200 bits/s.
NO DIALTONE 6 No dial tone detected.
BUSY 7 Busy signal detected.
NO ANSWER 8 Remote end never answered.
CONNECT 2400 EC* 10 Connection at 2400 bits/s.
CONNECT 4800 EC* 11 Connection at 4800 bits/s.
CONNECT 9600 EC* 12 Connection at 9600 bits/s.
CONNECT 14400 EC* 13 Connection at 14400 bits/s.
CONNECT 19200 EC* 14 Connection at 19200 bits/s.
CONNECT 7200 EC* 24 Connection at 7200 bits/s.
CONNECT 12000 EC* 25 Connection at 12000 bits/s.
CONNECT 16800 EC* 86 Connection at 16800bits/s.
CONNECT 300 EC* 40 Connection at 300 bits/s.
CONNECT 21600 EC* 55 Connection at 21600 bits/s.
CONNECT 24000 EC* 56 Connection at 24000 bits/s.