Airlink AML001 - Manual (Page 31)

PCI Modem Card User's Manual
30
by register S12 (see S12—Escape Guard Time), the escape guard time.
Register S2 (see S2—AT Escape Character) identifies the escape sequence
character.
A/—Repeat Last Command
Use this command to repeat the last AT command. The modem repeats the
command currently in the command buffer. Do not use the AT prefix with
this command. Do not conclude the command with a terminating character
such as enter.
A—Answer
This command instructs the soft modem to go off-hook and answer an
incoming call.
B—Communication Standard Setting
Use this command to select the communication standard used by the soft
modem.
B0 Selects CCITT V.22 mode when the modem is at 1200 bits/s.
B1 Selects Bell 212A when the modem is at 1200 bits/s (default).
B2 Deselects V.23 reverse channel (same as B3).
B3 Deselects V.23 reverse channel (same as B2).
B15 Selects V.21 when the modem is at 300 bits/s.
B16 Selects Bell 103J when the modem is at 300 bits/s (default).
C—Carrier Control
This command is supported to ensure compatibility with communications
software that issues the C1 command.
However, this modem does not support the C0 command. The C0 command
instructs some modems not to send carrier (i.e., it puts them in receive-only
mode).
C1 Normal transmit carrier switching (default).
D—Dial
This command instructs the soft modem to go off-hook and begin the dialing
sequence. The dial string (, including modifiers and the
telephone number) is entered after the D command.
A dial string can be up to sixty characters long. Any digit or symbol may be
dialed as touchtone digits. Characters such as spaces, hyphens, and