Airlink AML001 - Manual (Page 49)

PCI Modem Card User's Manual
48
+DR Data Compression Report Value
+DR=0
This command disables the compression report.
+DR=1 This command enables the compression report.
+DR Data Compression Reporting Intermediate Result Codes
+DR: NONE
Data compression is not in use.
+DR: V42B V.42 bis is in use in both directions.
+DR: V42B RD V. 42 bis is in use in the receive direction.
+DR: V42B TD V. 42 bis is in use in the transmit direction.
+DR: V44 V.44 is in use in both directions.
+DR: V44 RD V.44 is in use in the receive direction.
+DR: V44 TD V.44 is in use in the transmit direction.
+DS=,,,
—V. 4 2 bis Data Compression
Use the +DS command to configure the V.42 bis data compression method
used by the modem. The settings of this command overwrite the setting of a
%C command. However, it can also be overwritten by %C
command.
The parameter sets which directions use the compression method.
The soft modem use compression in one or both directions.
Valid Values:
0
Modem negotiates no V.42 bis compression.
1 Modem negotiates transmit only V.42 bis compression.
2 Modem negotiates receive only V.42 bis decompression.
3 Modem accepts V.42 bis compression in both or either
direction (default).
The parameter tells the modem whether it should
disconnect if V.42 negotiations fail.
The soft modem AT command set does not support the disconnect feature
when V.42 negotiation fails and the parameter is
always set to 0. The and parameters specify the
maximum number of dictionary entries and maximum string length for the
modem to negotiate. Their default values are 4096 and 32, respectively.
+DS44=,, ,
,,,
ing_rx>,,—V.44 Data Compression