Airlink AML001 - Manual (Page 39)

PCI Modem Card User's Manual
38
• CALL WAITING DETECTED
X5 Busy detection is enabled; blind dialing is disabled. The
dialing cannot be conducted unless a dial tone is detected. If
dial tone is not detected within the time specified by register
S6, the NO DIAL-TONE result code will be reported. The
following result codes are supported:
• OK • RING • NO CARRIER • ERROR
• NO DIALTONE • BUSY • CONNECT
• RRING • NO BONGTONE • DELAYED
• BLACKLISTED • WARBLE
• CALL WAITING DETECTED
Y—Long-Space Disconnect
This command is supported to ensure compatibility with communication
software that issues the Y0 command. Long-space disconnect is always
disabled.
Y0 Disables long-space disconnect (default).
Z—Reset and Recall Stored Profile
Use this command to force the soft modem to go on-hook and restore a
profile saved by the &W command. Soft modem products have two stored
profiles and the active profile. The parameter selects the stored
profile to copy into the active profile.
Z0 Reset and restore stored profile 0.
Z1 Reset and restore stored profile 1.
&B—V.32 Auto Retrain
This command is supported to ensure compatibility with communications
software that issues the B1 command. The B0 version of this command is not
supported.
&B0 Disable V.32 auto-retrain (not supported).
&B1 Enable V.32 auto-retrain (default).
&C—Data Carrier Detect (DCD) Control