Westermo TD-32 - Manual (Page 40)

40 6178-2203
S23 – General Bit Mapped Options Status (Read only register)
Bit Interval Default Description
0 0..1 0 Enables RDL:
0-Not allowed (AT&T5)
1-Allowed (AT&T4)
1..3 0..7 5 Current speed on
DTE (bps):
0-300
1-600
2-1 200
3-2 400
4-4 800
5-9 600
6-19 200
7-38 400 or higher
4..5 0..3 3 Current DTE parity:
0-Even
1-Logic 0 ”space”
2-Odd
3-Logic 1 ”mark”
6..7 0..2 0 Guard tone:
0-None (AT&G0)
1-None (AT&G1)
2-Guardtone 1800 Hz (AT&G2)
S24 – Receiver disconnect level
If %D1 is set, the value in this register will set the level of the lowest accepted line signal.
Default 0 {0..43} (dBm).
S25 – Delay To DTR (not stored with &W)
The modem will ignore an OFF condition for a period of time longer than is specified in this register.
Default 5 {0..255} (1/100 sec).
S26 – RTS to CTS delay (not stored with &W)
Sets the time the CTS signal is delayed at RTS/CTS handshake.
Works only in synchronous connections.
Default 1 {0..255} (1/100 sec).